Search results for "Test rig"
showing 6 items of 6 documents
Accelerated bearing life-Time test rig development for low speed data acquisition
2017
Condition monitoring plays an important role in rotating machinery to ensure reliability of the equipment, and to detect fault conditions at an early stage. Although health monitoring methodologies have been thoroughly developed for rotating machinery, low-speed conditions often pose a challenge due to the low signal-to-noise ratio. To this aim, sophisticated algorithms that reduce noise and highlight the bearing faults are necessary to accurately diagnose machines undergoing this condition. In the development phase, sensor data from a healthy and damaged bearing rotating at low-speed is required to verify the performance of such algorithms. A test rig for performing accelerated life-time t…
An experimental investigation on two different methods for swirl induction in a multivalve engine
2005
This paper describes an experimental investigation aimed at comparing the swirl effect induced by unbalancing the mass flow through the two intake ports of a multivalve engine head using two different methods: the first one reduced the curtain area of one of the intake valves [different lifts (DL) method]; the second one adopted a sluice-gate-shaped valve, installed upstream of the intake valves [swirl control valve (SCV) method] in order to cause a pressure drop. A steady-flow test rig (equipped with instrumentation for the discharge coefficient and swirl intensity measurement) was realized in order to compare and evaluate the results of both methods and determine their respective validit…
Numerical and Experimentical Study of Motion Control Using Pressure Feedback
2013
This paper is concerned with the inherent oscillatory nature of pressure compensated motion control of a hydraulic cylinder subjected to a negative load and suspended by means of an overcenter valve. A pressure feedback scheme that indirectly eliminates the oscillations is investigated. The indirect control scheme utilizes pressure feedback to electronically compensate the metering-out allowing for the removal of the compensator and, subsequently, elimination of the oscillations. The suggested electronic compensation scheme is implemented and examined in a single degree-of-freedom test rig actuated by means of a double acting hydraulic cylinder. The control scheme is compared with other con…
Experimental Investigation of Stall and Surge in a Multistage Compressor
2016
Flow instability conditions, in particular during surge and stall phenomena, have always influenced the operational reliability of turbo-compressors and have attracted significant interest resulting in extensive literature. Nowadays, this subject is still one of the most investigated because of its high relevance on centrifugal and axial compressor operating flow range, performance and efficiency. Many researchers approach this important issue by developing numerical models, whereas others approach it through experimental studies specifically carried out in order to better comprehend this phenomenon. The aim of this paper is to experimentally analyze the stable and unstable operating condit…
A Testing Facility for Refrigerating Plants Equipment Working with New Fluids
2013
A test rig was built in the department of energy, in laboratory of refrigerating engineering for test runs with a lot of fluid and equipment of various kind for commercial refrigeration. The facility has been continuously improved during the past years and allows to perform experiments aiming to assess the performance characteristics both of conventional and new equipment for commercial refrigeration. In the test rig can be tested a lot of cooling loop filled with a secondary fluid for simulation of their behavior in industrial and commercial plants (e.g.: during exploitation in supermarket and hypermarket for refrigeration of foodstuffs in cold store, display cases and cabinets, etc.). The…
A hierarchical model for novel schemes of electrodialysis desalination
2019
Abstract A new hierarchical model for the electrodialysis (ED) process is presented. The model has been implemented into gPROMs Modelbuilder (PSE), allowing the development of a distributed-parameters simulation tool that combines the effectiveness of a semi-empirical modelling approach to the flexibility of a layered arrangement of modelling scales. Thanks to its structure, the tool makes possible the simulation of many different and complex layouts, requiring only membrane properties as input parameters (e.g. membrane resistance or salt and water permeability). The model has been validated against original experimental data obtained from a lab scale ED test rig. Simulation results concern…